Pass/Fail A Lixer Calibration Tool

The Pass/Fail A Lixer has a pair of lines that are lasered for the push measurement, and a pair of lines that are lasered for the pull measurement, that are +/-1/32" from center at 6" or +/- .5mm from center at 100mm. This permits easy identification of standard and metric tape measures that are within this range. The laser lines can be aligned with the 1/32" marks on most [standard] tape measures. This will enhance your ability to verify accuracy by checking two 1/32" marks +/- at 6" or +/-  or +/- .50mm at 100mm on both the push and pull measurements. This tool can also be used to inspect rulers as well.

Pass Fail tape measure calibration tool

Pass/Fail Lixers come with a Certificate of Traceability to NIST (National Institute of Standards and Technology) valid for 1 year.

Accuracy +/-.002". Endorsed by This Old House Magazine

To Download Forms, please visit our ISO Compliance Page.

Initial order comes with padded Shipping / Storage box.  This box should be saved to use when sending the tool(s) back for recertification.

If you need your Lixer Tool with Independent or Accredited ISO certification, please email us at info@lixertools.com.  Due to the certificates being dated we do not keep these in stock. It takes about 7-10 days for the lab to get this certification completed.