Pass/Fail A Lixer Calibration Tool

Pass/Fail A Lixer Calibration Tool

The Pass/Fail A Lixer has a pair of lines that are lasered for the push measurement, and a pair of lines that are lasered for the pull measurement, that are +/-1/32" from center at 3" and 6" or +/- .5mm from center at 100mm. This permits easy identification of standard and metric tape measures that are within this range. The laser lines can be aligned with the 1/32" marks on most [standard] tape measures. This will enhance your ability to verify accuracy by checking two 1/32" marks +/- at 6" or +/- at 3" or +/- .50mm at 100mm on both the push and pull measurements. This tool can also be used to inspect rulers as well.

Pass Fail tape measure calibration tool

Pass/Fail Lixers come with a Certificate of Traceability to NIST (National Institute of Standards and Technology).

Accuracy +/-.002". Endorsed by This Old House Magazine

1 Item(s)

Set Descending Direction
per page

1 Item(s)

Set Descending Direction
per page